Skip to main

Vehicle Standard (Australian Design Rule 33/00 – Brake Systems for Motorcycles and Mopeds) 2007

In force
Administered by
  • Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

This item is authorised by the following title:

Superseded version
F2007L0270704 September 2007 - 30 November 2017

This standard was originally made under section 7 of the Motor Vehicle Standards Act 1989 and from 1 July 2021 continues in force as if it were a national road vehicle standard determined under section 12 of the Road Vehicle Standards Act 2018 (see Schedule 3, Part 2, item 2 of the Road Vehicle Standards (Consequential and Transitional Provisions) Act 2018).


Details

Title ID
F2007L02707
Registered
04 September 2007
Effective
04 September 2007 - 30 November 2017
Series
ADR 33/00
Type
Principal

Any available explanatory material for this instrument can be found on the Downloads tab

This standard was originally made under section 7 of the Motor Vehicle Standards Act 1989 and from 1 July 2021 continues in force as if it were a national road vehicle standard determined under section 12 of the Road Vehicle Standards Act 2018 (see Schedule 3, Part 2, item 2 of the Road Vehicle Standards (Consequential and Transitional Provisions) Act 2018).

Sunsetting

Most legislative instruments will sunset 10 years after registration under Chapter 3, Part 4 of the Legislation Act 2003.

This title is exempt from sunsetting by:

Disallowance and tabling

All legislative instruments that are registered must be presented for scrutiny in each House of the Parliament and, unless an exemption applies, they may be disallowed by either House. When documents are presented to the Australian Parliament for scrutiny, they are said to have been tabled.

This title is subject to disallowance under:

House of Representatives

  • Legislative Instrument
    11 September 2007

Senate

  • Legislative Instrument
    10 September 2007