Prescribed Goods (General) Amendment Orders 2004 (No. 4)

I, WARREN ERROL TRUSS, Minister for Agriculture, Fisheries and Forestry, make these Orders under regulation 3 of the Export Control (Orders) Regulations 1982.

Dated 25 November 2004

WARREN TRUSS

Minister for Agriculture, Fisheries and Forestry

1 Name of Orders

  These Orders are the Prescribed Goods (General) Amendment Orders 2004 (No. 4).

2 Commencement

  These Orders commence on 1 December 2004.

3 Amendment of Prescribed Goods (General) Orders 1985

  Schedule 1 amends the Prescribed Goods (General) Orders 1985.

Schedule 1 Amendments

(section 3)

[1] Order 87

substitute

87 Declaration of official marks

  For the purposes of the definition of official mark in section 3 of the Act, each of the following is declared to be an official mark:

 (a) a mark of the design set out in Schedule 1;

 (b) a stamp that applies that mark;

 (c) a mark of the design set out in Schedule 2;

 (d) a stamp that applies that mark

 (e) a mark of the design set out in Schedule 3;

 (f) a stamp that applies that mark;

 (g) a mark of the design set out in Schedule 4;

 (h) a stamp that applies that mark;

 (i) a mark of the design set out in Schedule 5;

 (j) a stamp that applies that mark;

 (k) a mark of the design set out in Schedule 6;

 (l) a stamp that applies that mark;

 (m) a seal of the design set out in Schedule 7;

 (n) a seal of the design set out in Schedule 8;

 (o) a seal of the design set out in Schedule 9;

 (p) a seal of the design set out in Schedule 10;

 (q) a mark of the design set out in Schedule 11;

 (r) a stamp that applies that mark;

 (s) a mark of the design set out in Schedule 12;

 (t) a stamp that applies that mark;

 (u) a mark of the design set out in Schedule 12A;

 (v) a stamp that applies that mark.

[2] After Schedule 12

insert

Schedule 12A Official mark specified in paragraph 87 (u)

(paragraph 87 (u))

1 Design of mark

  Subject to clauses 2 and 3, the design of the official mark referred to in paragraph 87 (u) is as follows (with XXXX replaced by a number identifying the office to which the stamp that applied the mark was allocated):

2 Size of mark

  The dimensions of the mark are to be as follows:

 (a) inner width, 37 mm;

 (b) outer width, 38 mm.

3 Lettering in mark

  The letters are to be in 9 point Helvetica Bold.