Federal Register of Legislation - Australian Government

Primary content

Airworthiness Directives as made
This instrument repeals and replaces AD/UH-1/20 Tail Boom and Fin - Fretting and Cracking to correct a typographical error in that instrument. This instrument mandates the requirements of the United States of America Federal Aviation Administration airworthiness directive 83-03-03 to ensure continuing airworthiness for Bell Helicopter Textron UH-1 (All Variants) Series Helicopters.
Administered by: Infrastructure, Transport, Cities and Regional Development
Exempt from sunsetting by the Legislation (Exemptions and Other Matters) Regulation 2015 s12 item 15
Registered 08 Oct 2019
Tabling HistoryDate
Tabled HR14-Oct-2019
Tabled Senate14-Oct-2019

AIRWORTHINESS DIRECTIVE

On the commencement date specified below, and for the reasons set out in the background section, the CASA delegate whose signature appears below repeals Airworthiness Directive (AD) AD/UH-1/20 and issues the following AD under subregulation 39.001 (1) of CASR and subsection 33 (3) of the Acts Interpretation Act 1901. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct an unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

Bell Helicopter Textron UH-1 (All Variants) Series Helicopters

AD/UH-1/20 Amdt 1

Tail Boom and Fin - Fretting and Cracking

21/2019

 

Applicability:

All models of Bell Helicopter Textron Inc UH-1 Series Helicopters.

Requirement:

Action in accordance with the technical requirements of Federal Aviation Administration of the United States of America (FAA) Airworthiness Directive (AD) 83-03-03 Amdt 39-4556 (FAA AD), as in force at the date of this AD.

Note 1:  The FAA AD paragraph b. references FAA Advisory Circular (AC) 43-13-1A paragraph 298, and FAA AC 43-3 Chapter 2 which have been superseded by FAA AC 43-13-1B. FAA AC 43-13-1B Chapter 5 Section 6, as in force at the date of this AD, can be used in lieu of both FAA AC 43-3 (Chapter 2) and paragraph 298 of FAA AC 43-13-1A.

Note 2:  A different non-destructive inspection method, other than the radiographic inspection method, to that detailed in the FAA AD can be used if approved by CASA in writing as an alternative method of compliance.

Compliance:

As specified in the Requirement document, but with a revised initial inspection date of within 14 days after the commencement date of this AD, unless previously accomplished.

 

This AD commences on 11 October 2019.

Background:

FAA AD 83-03-03 Amdt 39-4556 effective 14 March 1983 was issued to detect cracks and prevent possible failure of the tail boom and fin. The FAA had determined that tail boom skin cracks occurred in a model UH-1B which crashed. A metallurgical examination revealed cracks to be due to structural fatigue.

Since this condition is likely to exist or develop on other helicopters of the same design, the FAA AD was issued. The AD requires visual and radiographic inspections for fretting and cracking, and repair or replacement, as necessary, of the tail boom skin and the fin spar cap on Bell Helicopter Textron Inc Model UH-1 series helicopters.

CASA’s predecessor conducted a review of FAA AD 83-03-03 Amdt 39-4556 on 9 March 1983. At the time of the review no Bell Helicopter Textron Inc UH-1 series helicopters were on the Australian civil aircraft register.

 

 

 

It has since come to CASA’s attention that Bell Helicopter Textron Inc UH-1 series helicopters have now been placed on the Australian civil aircraft register and will require inspections to be accomplished in accordance with FAA AD 83-03-03 Amdt 39-4556.

This amendment corrects the FAA AC 43-13-1B reference in Note 1.

A drawing of a face

Description automatically generated

Pieter van Dijk
Delegate of the Civil Aviation Safety Authority

4 October 2019