Federal Register of Legislation - Australian Government

Primary content

AD/DH 83/6 - Inspection of Wooden Structure

Authoritative Version
AD/DH 83/6 Airworthiness Directives as made
This instrument requires, in accordance with the Technical News Sheet CT (Moth), No. 32 Issue 3 issued by de Havilland Support Limited, visual inspections of the entire internal wooden structure of the flying surfaces of all variants of DH 83 aircraft to ensure the continued airworthiness of the aircraft.
Administered by: Infrastructure, Regional Development and Cities
Exempt from sunsetting by the Legislation (Exemptions and Other Matters) Regulation 2015 s12 item 15
Registered 04 Feb 2015
Tabling HistoryDate
Tabled HR09-Feb-2015
Tabled Senate09-Feb-2015

 

AIRWORTHINESS DIRECTIVE

On the effective date specified below, and for the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.001 (1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct an unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

de Havilland DH 83 (Fox Moth) Series Aeroplanes

AD/DH 83/6

Inspection of Wooden Structure

3/2015

 

Applicability:

This AD applies to all variants of DH 83 aircraft.

Definitions:

In this AD:

DHSL means de Havilland Support Ltd.

TNS means DHSL Technical News Sheet CT (Moth) No. 32, Issue 3, dated 1 December 2008.

Requirement:

For all aircraft:

1.    Unless previously accomplished:

(a)   install all inspection rings and drainage provisions in accordance with the provisions of Figure 3 of Appendix G of the TNS;

(b)   gain access to the internal structure by removing all ‘pop-in’ panels, or otherwise cut away the fabric from inside inspection rings to facilitate access to the entire internal wooden structure;

(c)   perform a detailed inspection of the internal wooden structure in accordance with the inspection criteria provided at Appendix B, paragraph 6 ‘Inspection Content’ and take into consideration Appendix F, page F17, paragraph 2 ‘DH83 Fox Moth Wooden Structure – Areas for Specific Inspections’ of the TNS;

(d)   remove all unserviceable wooden structure from service, or conduct repairs in accordance with approved data.

2.    Report all defects discovered to CASA via the Service Difficulty Reporting System.

Compliance:

1.    The actions in Requirement 1 must be taken:

(a)   for aircraft used for commercial purposes as prescribed in regulation 206 of the Civil Aviation Regulations 1988 (CAR 1988) – within two months of the effective date of this AD;

(b)   for all other aircraft – by the end of 31 December 2015.

 

       The actions in Requirement 1 must be repeated at the earlier of the following:

(i)    every 200 hours;

(ii)   within 36 months of the previous inspection;

(iii)  in the event of a ground strike, birdstrike or any other wing strike of sufficient magnitude to leave witness marks on the fabric covering, or otherwise obvious damage to a wing. In the case of such an event, both the top and bottom wings are to be inspected on the side of the aircraft where the impact occurred.

2.    The action in Requirement 2 must be taken in accordance with Part 4B – Defect Reporting of CAR 1988.

 

The effective date of this AD is 6 February 2015.

Background:

This AD will mandate the requirement to conduct visual inspections of the entire internal wooden structure of the aircraft’s flying surfaces to ensure the continued airworthiness of all variants of DH 83 aircraft.


Nicholas Ward
Delegate of the Civil Aviation Safety Authority

2 February 2015