Statutory Rules 1986 No. 3701

National Measurement (Patterns of

Instruments) Regulations2 (Amendment)

I, THE GOVERNOR-GENERAL of the Commonwealth of Australia, acting with the advice of the Federal Executive Council and after taking into consideration recommendations made by the National Standards Commission to the Minister of State for Science with respect to regulations to be made for the purposes of sub-section 19a (1) of the National Measurement Act 1960, hereby make the following Regulation under that Act.

Dated 11 December 1986.

N. M. STEPHEN

Governor-General

By His Excellency’s Command,

Barry Jones

Minister of State for Science

—————

Certificate of approval

Regulation 9 of the National Measurement (Patterns of Instruments) Regulations is amended—

(a) by omitting from paragraph (3) (d) “and”; and

(b) by adding at the end of sub-regulation (3) the following word and paragraph:

“and; (f) an amount of error that may be tolerated in instruments of the same kind as the instrument in respect of the pattern of which the certificate is issued.”.

NOTES

1. Notified in the Commonwealth of Australia Gazette on 19 December 1986.

2. Statutory Rules 1965 No. 147 as amended by 1966 No. 66; 1984 No. 232.

Printed by Authority by the Commonwealth Government Printer

(S.R. 285/86)—Cat. No.     10/25.8.1986